LD/body /skeleton

Body / Structure

Structure & posture

The load-bearing reference architecture for posture, movement, protection, routing and service access.

Engineering candidate
Abstract blank humanoid hand in green, ivory and gold materials

Leeloo Digital / Homo sapiens technologicusBody / Structure

01 / Technical scope

The HST skeleton is the body-wide datum to which joints, actuators, protective volumes, surfaces and internal networks are registered.

The structural system is defined around human proportions and human environments. It must carry standing, walking, sitting, lifting, falls, ordinary impacts and controlled physical contact while preserving the movement clearances required by joints and soft surfaces.

The macro design separates primary load paths, local reinforcement, protected equipment zones and replaceable joint interfaces. Structural members also provide references for actuator attachment, tendon-equivalent routing, cable and fluid corridors, skin support and service fixtures.

Preliminary CAD must reconcile geometry across adjoining regions, identify load-transfer interfaces and reserve access before detailed member sections or materials are selected. Structural analysis, fatigue work and physical testing remain later evidence gates.

Public information describes these functions and verification needs. Dimensions, section geometry, joining methods, material selections, tolerances and load limits remain proprietary engineering data.

02 / Body requirements

01

Primary load paths

Carry body mass, external loads and actuator reactions through defined structural routes.

02

Joint registration

Maintain stable joint centers, alignment and replaceable bearing or interface zones.

03

Protected volumes

Shield energy, compute, sensory and artificial-physiology systems according to consequence.

04

Network corridors

Reserve controlled passages for power, data, thermal and fluid systems without weakening critical regions.

05

Service references

Provide repeatable support, lifting, alignment and inspection points for maintenance.

03 / Body-system definition

Functional requirements by body system

01Structural definition

Axial and appendicular structures form one load system

The head, vertebral column, thorax and pelvis establish the axial reference. Shoulder, arm, hand, leg and foot structures transfer loads into it through controlled regional interfaces.

Local design can vary by region, but the complete load path must remain continuous through posture changes and asymmetric movement.

02Preliminary engineering

Geometry is developed together with motion and access

Reference CAD establishes anthropometric envelopes, joint locations, structural zones, attachment regions and keep-out volumes.

Kinematic sweeps and service studies are performed before detailed optimization so strength is not achieved by blocking movement or maintenance.

03Evidence

Strength is only one acceptance category

Analysis must address stiffness, fatigue, buckling, impact, local damage, joint loads and degraded configurations.

Representative articles are required where material behavior, joining, cyclic loading or inspection capability cannot be established credibly by calculation alone.

04 / Body engineering

Definition through integration

01Complete

Macro structural allocation

Structural responsibilities, body regions and principal interface classes are assigned.

02Current

Reference CAD and load cases

Develop spatial definition, joint references, access zones and the controlled load-case set.

03Next

Analysis and material decisions

Evaluate candidate structural concepts against mass, fatigue, protection and service requirements.

04Later

Representative structural verification

Test bounded assemblies before authorizing whole-body structural integration.