LD/body /muscles

Body / Motion

Movement

Actuation, force transmission, compliance and control for the complete range of human movement and more.

Research challenge
Abstract blank humanoid hand in green, ivory and gold materials

Leeloo Digital / Homo sapiens technologicusBody / Motion

01 / Technical scope

Human-like movement requires coordinated force paths, variable compliance and continuous body-state sensing—not motors arranged around a pose.

The motion architecture allocates joint actuation, distributed muscle-equivalent groups, tendon-equivalent transmission, elastic behavior and local control across the complete body. Different regions may use different actuator families when their interfaces and control behavior remain coherent.

Requirements cover quiet posture, walking, running, climbing, rising, reaching, lifting, fine manipulation, facial motion and safe contact. Peak force matters, but ordinary low-speed control, efficiency, noise, heat, backdrivability and fatigue dominate much of daily life.

Preliminary engineering defines joint trajectories, moment requirements, actuator zones, transmission paths, sensing, movement clearances and fault behavior. It does not yet claim qualified actuators or verified whole-body performance.

Detailed mechanisms, transmission geometry, control gains, force limits and component selections remain confidential.

02 / Body requirements

01

Force production

Supply the torque and linear force required by posture, locomotion, manipulation and expression.

02

Compliance

Yield safely during contact while maintaining controllable posture and precision.

03

Force transmission

Route actuator output through monitored tendon-, cable- or linkage-equivalent paths.

04

Body coordination

Coordinate gaze, torso, balance, limbs and hands as one action rather than isolated joints.

05

Condition awareness

Detect friction, backlash, fatigue, overheating, overload and changing mechanical response.

03 / Body-system definition

Functional requirements by body system

01Movement model

Motion begins with tasks and trajectories

The engineering basis is a controlled library of postures, transitions, contacts and external loads spanning ordinary and extended capability.

These cases determine joint ranges, speed, acceleration, torque, stiffness and endurance requirements before hardware is committed.

02Actuation architecture

Regional actuator groups share whole-body constraints

Actuator placement competes with structure, power, cooling, sensing, surface depth and service access.

Transmission can relocate mass or distribute force, but it also introduces routing, friction, fatigue, tensioning and replacement requirements that must be monitored.

03Verification

Natural movement must be measurable

Acceptance includes trajectory accuracy, contact force, disturbance recovery, acoustic output, thermal behavior, energy use and graceful degraded operation.

Human-factors studies then assess whether technically acceptable motion is also legible, comfortable and safe around people.

04 / Body engineering

Definition through integration

01Complete

Macro movement allocation

Body regions, movement functions and actuator responsibilities are defined.

02Current

Kinematics and preliminary actuation

Resolve joint geometry, movement envelopes, force cases and candidate actuator classes.

03Next

Dynamic and thermal analysis

Evaluate force, control, energy, heat, fatigue and fault behavior.

04Later

Regional motion rigs

Verify bounded limb, torso, hand and balance functions before coordinated integration.